SAE J1453 EPUB
Browse SAE J ORFS O-Ring Face Fittings in the World Wide Metric, Inc. catalog including Nuts and Rings,Equal Fittings,Male Stud Coupling,Bulkhead. The Seal-Lok fitting meets or exceeds the strict requirements of SAE J and ISO It is an O-ring face seal type fitting that consists of a nut, a body. Thread Specification – ORFS (SAE J). TECHNICAL DATA. SAE J, ISO ORFS is O RING FACE SEAL. ORFS system consists of ORFS.
|Published (Last):||13 September 2017|
|PDF File Size:||1.52 Mb|
|ePub File Size:||5.95 Mb|
|Price:||Free* [*Free Regsitration Required]|
Inch hex dimensions of parts will be moved from the main document to an informative annex after These connectors are intended for general application see Figures sae j1453, 4, and 5 and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable sae j1453 overcome leakage and variations in assembly procedures. IHS Standards Expert subscription, simplifies and expedites the process for finding and managing standards by giving you access to standards from over standards developing organizations SDOs.
For new designs metric tubing should be considered. Click sae j1453 to skip or ad will close in 15 seconds. J153 of Application These connectors are intended for general application see Figures 3, 4, and 5 and hydraulic systems on industrial equipment and commercial products, where sae j1453 seals are acceptable to overcome leakage and variations in assembly procedures.
The three parts of SAE J cover material, dimensional, and performance requirements of steel O-ring face seal ORFS connectors for tubing and the O-ring sae j1453 seal interface and sae j1453 portion of sae j1453 stem assemblies for nominal tube diameters of 6 mm through 50 mm.
These connectors are capable of providing leak proof full flow connections in hydraulic systems operating from 95 kPa vacuum to working pressures shown in Table 4. Purpose The three parts of SAE J cover material, dimensional, and performance requirements of steel O-ring face seal ORFS connectors for tubing and the O-ring face seal interface and nut portion of hose stem assemblies for nominal tube diameters of 6 mm through 50 mm.
ORFS MALE O-RING SEAL ISO SAE J hydraulic test fittings – Ruihua Hardware
SAE J covers the requirements for O-ring sae j1453 seal connectors to inch stud ends along with the associated adapters, bulkhead and union connectors.
This standard is available for individual purchase.
Since many factors influence the pressure at which a hydraulic system will or will j453 perform satisfactorily, these values should not be sae j1453 as guaranteed minimums.
For sae j1453 of these connectors in conditions outside the pressure and temperature limits specified, the manufacturers must be consulted.
Adapter SAE J with Swivel Nut / BSI On World Wide Metric, Inc.
Speed up research, capture and reuse expertise For additional product information, visit the IHS Sae j1453 Expert page. Price and Buy this Standard View Pricing. Identify unmet needs and discover next-generation technologies Improve quality by leveraging consistent standards to meet customer and market requirements Minimize risk: Mitigate liability and better understand compliance regulations Boost efficiency: For any application, it is recommended that sufficient testing be conducted and reviewed by both the user and sae j1453 to ensure that required performance levels are met.
The rated working pressure of a fluid conductor assembly using SAE J hose stem connections sae j1453 formed tube or braze-on tube connections shall not exceed rated working sae j1453 of the lowest rated component thereof.