SIKAFLEX 11 FC PDF
SIKA Sikaflex 11FC All in One Adhesive Sealant Black Brown Grey White Multipurpose all in one elastic sealant and bonding adhesive Seals, Bonds and. 24 Jan SikaflexÆ FC. One part advanced polyurethane, elastomeric sealant/ adhesive. Description. Sikalex FC is a one-component, gun-grade. Specialist Construction Supplies for Repair, Maintenance, Building & Infrastructure. Sikaflex 11FC Data Sheet. Specification notes. Product: Sikaflex 11FC.
|Published (Last):||10 August 2017|
|PDF File Size:||15.91 Mb|
|ePub File Size:||7.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
Maximum joint width 30mm. Collect with suitable absorbent material. Cut the plastic nozzle according aikaflex the desired bead width and then pierce the internal metal seal carefully to ensure that the passage of the sealant to the nozzle is not impeded.
Tensile Strength DIN 53 Ensure that all traces of release agents, curing compounds and silicone treatments are removed, or perform a site test to determine whether adequate adhesion can be obtained.
Refer to consumption chart on last page of this technical data sheet. Light weight building components Sheet metal enclosures, metal roof flashings Silos and claddings Pipe entries, unions and sikalex Ventilation ducts Pointing of windows – fixing of window sills Kitchen installations Floor and construction joints.
Sika Primer 3 ml and 1 litre containers. In practice, the differences in materials, substrates and actual site conditions are such that no warranty in respect of merchantability or of fitness for a particular purpose, nor any liability arising out of any legal relationship whatsoever, can be inferred either from this information, or from any written recommendations, or from any other advice offered.
SIKA Sikaflex 11FC All in One Adhesive Sealant Black Brown Grey White
Safety goggles and chemical resistant gloves are recommended. Priming is not usually necessary on new surfaces. When constructing a joint the following measurements have to be observed: Install bond breaker cord in construction and expansion joints to prevent the sealant bonding to the base of the joint. Flush immediately with water for 10 – 15 minutes and contact a physician.
Keep away from open flames and high heat. Install the cartridge directly into a normal skeleton gun. Exercise care, as with handling any chemical construction product. Masking tape should be applied where staining may occur. Wash hands immediately after use. Users should always refer to the most recent issue of the Technical Data Sheet for the product concerned, copies of which will be supplied on request, or can be accessed on the internet under www. Contact Sika for further health and safety information.
All surfaces must be clean, sound, dry and properly cured. Concrete grey, brown, white and black.
Protect from direct sunlight. Ambient and surface temperatures must be between 50C to C during application.
SIKA Sikaflex 11FC All In One Adhesive Sealant Black Brown Grey White
The Company reserves itself the right to change the formulation of Sika products if so required by new research and development. After the sealant has been applied to the joint, it can be smoothed using a spatula lubricated with diluted washing-up liquid Elongation at Break DIN 53 All primers should be applied as thinly as possible.
Wash clothing before re-use.
Dispose of in accordance with local regulations. The proprietary rights of third parties must be observed. Squeeze the trigger firmly to force the sealant through the nozzle.
Remove all loose material mechanically, with a wire brush, or by water or sand blasting as necessary. Remove contaminated clothing sikaflwx. Cured material can only be removed mechanically.
Wash thoroughly with soap and water.